Configure a second uplink access pointĪ downlink access point can only connect to a single uplink access point at the time. The downlink access point will report in the overview tab the Uplink access point to which it’s connected and the signal strength of the connection. When the wireless uplink is active we can view the details of the connection in the overview of the access points. It lists the device as wired connected directly to the main switch, where actually the uplink access point is connected. I have tested the wireless bridge setup, somehow my Unifi Network Console doesn’t show the client behind the downlink access point in the topology view. Another option is to use a PoE-capable switch, in that case, you can simply connect the switch straight to the downlink access point. The only extra step that you will need to do, is to connect your switch or device to the LAN port of the PoE adapter. To create a wireless bridge you simply need to follow the steps described above to create a wireless uplink connection. This way you can create a wireless connection to your garage in your garden and connect an Unifi Switch and camera on the downlink access point. The Wireless Uplink function on the Unifi access points can be used to create a wireless bridge. When it’s online you should see that it’s connected to your Uplink access point: Wireless Uplink Creating an Unifi Wireless Bridge You might also see briefly the status Isolated. It can take a couple of minutes until the access point reappears Online in the network console. Place the access point within range of the uplink access point and powered it on with only a PoE Adapter. With the Unifi Wireless Uplink configured you can now disconnect your access point from the switch. Unifi Downlink Access Point Step 4 – Place your Downlink Access Point
0 Comments
Leave a Reply. |